2000–2006 Toyota Tundra & Sequoia Center Console Tray – Vertical Phone Stand + MagSafe Ready | 3D Printed ASA, 1st Gen

Your factory tray is a flat plastic pan. Take one corner with any speed and everything in it ends up on the passenger floor.

Toyota gave the 1st Gen Tundra and Sequoia a console tray with no walls, no dividers, and no plan. Twenty years later you're still fishing your sunglasses out from under the seat.

This is a direct drop-in replacement for that tray — same clips, same opening. No drilling, no adhesive, no trimming. The OEM piece pops out and this drops in its place in under two minutes.

What changes the day you install it

Deep, walled compartments. Separated bays with real walls and flat floors. Keys, wallet, sunglasses, tire gauge, garage remote — everything gets a spot and stays in it through a hard turn.

A vertical phone stand, angled for the driver. Not a flat slot. Your phone stands up in portrait, with the case on, screen turned toward the driver's seat where you can actually read it. Navigation stays visible without taking a hand off the wheel or wedging your phone in a cupholder.

Routed for a charging cable. The phone bay is cut so a cable runs in cleanly and stays put while the phone sits in the stand. No wire draped across the shifter.

MagSafe ready. The phone bay accommodates an Apple MagSafe charger — so you can set your phone down and charge it wirelessly in a truck built before wireless charging existed. One factory part you were never using properly, replaced with something that makes a twenty-year-old interior feel current.

Built to live in a truck

Printed in black ASA — the same material used for automotive exterior trim. ASA is UV stable and heat resistant, so it won't fade, chalk, or warp on a sun-exposed console through a desert summer. This is not PLA. It will not soften in a hot cab.

Fitment

• 2000–2006 Toyota Tundra
• 2001–2007 Toyota Sequoia
• Direct OEM replacement — uses factory clip locations
• No drilling, no cutting, no adhesive
• Install time: under 2 minutes

Made in Ivins, Utah

Designed, printed, and finished by one person in southern Utah. Every part is inspected before it ships.

PRODUCTION UNITS COMING SOON. Final design revisions are being completed now. Photos shown are a fitment prototype — production parts are printed in black ASA at full finish quality.

Want one from the first batch? Email William@alpinetrailco.com and I'll put you on the list. First-batch buyers get notified before it goes public.