2003–2006 Toyota Tundra & 2001–2007 Sequoia Baja Designs Squadron Fog Light Housing – ASA 3D-Printed Replacement

Run Baja Designs Squadrons Without Cutting Anything
Sold as a set of two housings — driver and passenger side. Direct replacement housings for both factory fog light locations — built specifically around Baja Designs Squadron lights. Reuses the stock retention clips and vibration pads, so the fit is factory-tight with no drilling, no fabrication, and no modifications to your bumper.
Clean OEM+ look, significantly better light output.
What's included
∙ (1) Driver-side ASA 3D-printed housing
∙ (1) Passenger-side ASA 3D-printed housing
Fitment
Purpose-built for these platforms — not a universal bracket.
✅ Fits 2003–2006 Toyota Tundra (1st Gen)
✅ Fits 2001–2007 Toyota Sequoia (1st Gen)
Construction
Printed in ASA — heat resistant, UV stable, built for under-bumper exposure and trail use.
Housings only. Baja Designs Squadron lights not included and must be purchased separately.

Complete the setup
∙ Auxbeam 8-switch dash panel — wire your Squadrons to a clean factory-location switch
∙ 1st Gen Tundra & Sequoia steel MOLLE panel set
∙ New to this? Read the full 1st Gen Tundra fog light install guide (no cutting) →
∙ Shop all Tundra & Sequoia gear →